[HARLEQUIN][Common Lisp HyperSpec (TM)] [Previous][Up][Next]


22.1.3.2 Printing Characters

When printer escaping is disabled, a character prints as itself; it is sent directly to the output stream. When printer escaping is enabled, then #\ syntax is used.

When the printer types out the name of a character, it uses the same table as the #\ reader macro would use; therefore any character name that is typed out is acceptable as input (in that implementation). If a non-graphic character has a standardized name[5], that name is preferred over non-standard names for printing in #\ notation. For the graphic standard characters, the character itself is always used for printing in #\ notation---even if the character also has a name[5].

For details about the #\ reader macro, see Section 2.4.8.1 (Sharpsign Backslash).


The following X3J13 cleanup issue, not part of the specification, applies to this section:


[Starting Points][Contents][Index][Symbols][Glossary][Issues]
Copyright 1996, The Harlequin Group Limited. All Rights Reserved.